How long does it take Armorseal tread-plex to dry?
28 days
Surfaces should be thoroughly clean and dry. Concrete and mortar must be cured at least 28 days @ 75°F (24°C).
Is Armorseal tread-Plex an epoxy?
100% Solids Self-leveling Epoxy — ArmorSeal®Tread-Plex Primer.
How long does Rexthane take to dry?
Heavy Traffic: 7 days 3 days 3 days Refer to Product Information sheet for additional performance characteristics and properties.To cure: 7 days 3 days 3 daysDrying time is temperature, humidity and film thickness dependent.
How long does tread Plex take to dry?
310.2R, CSP 1-3. Surfaces should be thoroughly clean and dry. Concrete and mortar must be cured at least 28 days @ 75°F (24°C).
Do I need to Prime armorseal treadplex paint?
Need help. Armorseal treadplex for porch | DIY Home Improvement Forum Need help. Armorseal treadplex for porch I went down to Sherwin Williams and the rep said i dont need to prime with Treadplex paint, he said its self priming.
What is armorseal tread-Plex?
A single-component, general purpose, interior/exterior, 100% acrylic, water-borne floor coating. Through a rapid drying process, Armorseal® Tread-Plex™ turns to a tough, alkali-resistant finish which will withstand hard wear, abrasion, grease, oils and cleaning equipment.
How do I get tredplex to stick to a previously coated floor?
Basically you need to grind or blast the surface to be coated. I wouldn’t worry about profile on a previously coated floor. Tredplex is a very nice acrylic foot traffic coating and adheres very well. It is very thin and spreads easy, recoats quick as well. I would just make sure the floor is clean, quick sand, then two coats.
What kind of primer to use with Behr tredplex?
Latex Primer: Good for Drywall, that’s about it. Behr Paint: The plastic buckets are good, that’s about it. Technically speaking, as per the bulletin spec sheet, there is a tredplex primer to be used with the tredplex top coat.