How to access WAP610N?

How to access WAP610N?

Setting up the Linksys WAP610N Dual-Band Wireless-N Access Point

1. Connect the access point to the router.
2. Obtain the IP Address of the access point.
3. Access the access point’s web-based setup page.
4. Set the IP Address of the access point.
5. Configure the wireless settings of the access point.

How to reset Linksys router?

1 Factory Reset

1. Ensure the router is ON.
2. Using a paper clip, push and hold the Reset button.
3. Hold the reset switch for 10-15 seconds.
4. Disconnect and reconnect the router’s power adapter.
5. Once it fully reboots, you can use the default username and password to connect the device.

How do I reset my Cisco WAP610N?

To reset your WAP610N to factory defaults, press and hold the Reset button at the access point’s back for 30 seconds.

How do I log into my Linksys admin?

How to access the router’s web interface

1. Launch a web browser and enter “192.168. 1.1” in the Address bar then press [Enter].
2. Enter your login credentials in the fields provided. The default password is admin.
3. To know if you have successfully logged in to the web interface, the screen below should appear.

What is default login for Linksys router?

The router’s default Password is “admin”, as for the User name, you can leave the field blank. For security purposes, it is recommended to change the default password. QUICK TIP: Changing the router’s password through the web-based setup page may prevent you from using the Linksys Connect software.

What is Linksys admin password?

admin
Linksys routers use “admin” as the default administrator password.

What is the default IP address of the wap610n?

There is no default IP address. The device uses DHCP from your router to get an IP address. 3. What is the default username and password used to access the web-based setup page of the WAP610N? By default, the username is left blank and the pa ssword is admin. 4. What is the speed of the Ethernet port on the WAP610N? The speed is 10/100 Mbps. 5.

How to set up the Linksys wap610n dual-band Wireless-N access point?

Setting up the Linksys WAP610N Dual-Band Wireless-N Access Point. To configure the access point, follow the instructions below: Step 1: Launch your web-browser and enter the IP Address of the access point in the Address bar. Step 2: Leave the User name blank and enter “admin” in the Password field. Then, click OK.

What is the Wi-Fi Protected Setup™ button?

Wi-Fi Protected Setup™ Button If you have client devices, such as wireless adapters, that support Wi-Fi Protected Setup™, then you can use Wi-Fi Protected Setup™ to automatically configure wireless security for your wireless network.